6-12 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
6.4.2.2 Resetting the NVRAM Permanently
When the ok prompt is displayed, typing set-defaults discards any customized
NVRAM values and permanently restores the default values for all NVRAM
configuration parameters. See
TABLE 6-2 for NVRAM configuration parameter default
values.
6.4.2.3 Workstation Power Cycling
Use one of the following two methods to perform a workstation power cycle by
shutting down and immediately restarting the workstation:
■ System reboot
A system reboot shuts down any running applications and the operating system,
then restarts the operating system. A system reboot does not take to the
workstation to a standby power state.
■ Shutdown and Power On
Powering off the workstation shuts down any running applications and the
operating system, and takes the workstation to a standby (power-off) state. To
restart the workstation, you must manually press the Power button, which
initiates the boot process.
ttyb-mode 9600,8,n,1,- Serial2 ( ) port
default settings. See
“Setting Up for POST” on
page 7-2.
TABLE 6-4 Stop-N Equivalent Configuration Parameters (Continued)
Parameter Stop-N Equivalent Value Description
2
To Next Page
Loading...
