6-8 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
3. Set the security mode to full or command. Type:
4. Enable the security-mode. Type:
Upon reset, the ok prompt appears as a > symbol and the password is required. For
example:
After supplying the correct password, the command is run. If an incorrect password
is supplied, the user is required to wait for 10 seconds until authorization can be re-
attempted. For example:
6.3 eeprom Command
It is possible to display and change NVRAM configuration parameters from the
Solaris operating system by using the eeprom command. The eeprom command is
executed by superuser in the form of:
ok setenv security-mode full
security-mode = full
ok
ok reset-all
> printenv
Firmware Password:
> printenv
Firmware Password:
Sorry. Waiting 10 seconds.
>
# eeprom parameter=value
To Next Page
Loading...
