Sun Microsystems Blade 1500 - Page 191

Chapter 9 SunVTS 9-5
Network
6. Select Network.
7. Click Reset.
8. Click Start.
Connection test starting....
Connection test complete
Serial ports
6. Select Comm. Ports.
7. Click Reset.
8. Click Start.
Comm.Ports
su0
Status: Idle:
/dev/term/a:
Idle, current baud = 9600, maximum baud = 115200,
/dev/term/b:
Connection test complete
Parallel
port
6. Click the plus sign adjacent to
Other Devices.
7. Select ecpp0(eccptest).
8. Click Reset.
9. Click Start.
Connection test starting....
OtherDevices
ecpp0
Status: Idle:
/dev/ecpp0:
IEEE 1284 parallel port,
Port mode = ECPP_CENTRONICS (non-IEEE
1284 compliant device mode - Centronics only)
Connection test complete
Speaker
6. Click the plus sign adjacent to
Other Devices.
7. Select sound0(audiotest).
8. Click Reset.
9. Click Start.
Connection test starting....
audio: Playing 2 second(s) 1 KHz tone through the speaker
port...Connection test complete
done.
sound0
Status: Idle:
/dev/sound/0:
AC97 Codec, 16-bit Stereo, 48 KHz sample rate
System
sensors
6. Click the plus sign adjacent to
Other Devices.
7. Select adm1031(env3test).
8. Click Reset.
9. Click Start.
Connection test starting....
adm1031
Status: Found
cpu-fan (fan. 460000053e)
intake-fan (fan. 4600000544)
outtake-fan (fan. 460000054a)
cpu (temperature-sensor. 460000051d)
int-amb (temperature-sensor. 4600000528)
sys-in (temperature-sensor. 4600000533)
Connection test complete
TABLE 9-1 Subsequent Steps to Test Components in Connection Mode (Continued)
Component Steps to Take Successful Test Results