8-14 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
8.2.6.5 ide@d Test
The following is an example of a successful ide@d test:
8.2.6.6 network@2 Test
The following is an example of a successful network@2 test:
obdiag> test 5
Hit the spacebar to interrupt testing
Testing /pci@1e,600000/ide@d
>> Primary interface selected.
Subtest pci-config-reg-tests
Subtest pci-config-reg-tests:vendor-id-test
Subtest pci-config-reg-tests:device-id-test
Subtest pci-config-reg-tests:status-reg-test
Subtest pci-config-reg-tests:rom-expansion-test
>> Primary interface selected.
Subtest pri-cmd-blk-reg-test4
>> Testing IDE Command register
>> Make sure IDE device is attached
Subtest reset&check-diag
>> Checking device reset capability
Subtest identify-ata
>> Checking that an ATA device is attached.
>> ATA disk responds to Identify Device Command
ATA Model: ST3120026A
>> Secondary interface selected.
Subtest sec-cmd-blk-reg-test4
>> Testing Secondary IDE Command register
>> Make sure IDE device is attached
Subtest reset&check-diag
>> Checking device reset capability
Subtest identify-atapi
>> Checking that an ATAPI device is attached.
>> ATAPI device responds to Identify Packet Device Command
>> Removable ATAPI Model: LITE-ON COMBO SOHC-4832K
Selftest at /pci@1e,600000/ide@d ...................................... passed
Pass:1 (of 1) Errors:0 (of 0) Tests Failed:0 Elapsed Time: 0:0:0:1
obdiag> test 6
Hit the spacebar to interrupt testing
Testing /pci@1f,700000/network@2
Subtest reset-tests
Subtest reset-tests:mac-global-reset-test
Subtest reset-tests:tx-risc-reset-test
To Next Page
Loading...
