Preface xxxiii
Chapter 8 instructs how to use OpenBoot Diagnostics to troubleshoot the Sun Blade
1500 workstation.
Chapter 9 summarizes using SunVTS software to exercise a Sun Blade 1500
workstation and its components.
Chapter 10 provides preliminary steps necessary to prepare for component
replacement.
Chapter 11 contains replacement procedures for components found on the
motherboard.
Chapter 12 has replacement procedures for data storage components.
Chapter 13 explains replacement procedures for components that are part of the Sun
Blade 1500 chassis.
Chapter 14 describes how to replace system cabling.
Chapter 15 provides steps to finish component replacement.
Chapter 16 describes how to customize your Sun Blade 1500 workstation.
Appendix A lists the specifications of the Sun Blade 1500 workstation.
Appendix B outlines the external signal descriptions.
Appendix C provides a functional description of the Sun Blade 1500 workstation.
Appendix D describes how to manage power-saving modes of the Sun Blade 1500
workstation.
Safety Information
Read this section before beginning any procedure in the Sun Blade 1500 Diagnostics,
Service, and Troubleshooting Manual. For your protection, observe the following safety
precautions when removing or installing components, configuring, and
troubleshooting your Sun Blade 1500 workstation.
■ Follow all cautions and instructions marked on the equipment.
■ Make sure that the voltage and frequency of your power source match the voltage
and frequency inscribed on the equipment’s electrical rating label.
■ Never push objects of any kind through openings in the equipment. Dangerous
voltages might be present. Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage to your equipment.
To Next Page
Loading...
