vi Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
6.4.2 Stop-N Equivalent Command Procedure 6–10
7. Power-On Self-Test 7–1
7.1 The post Command 7–1
7.1.1 Diagnostic Levels 7–2
7.1.2 Output Verbosity 7–2
7.2 Setting Up for POST 7–2
7.2.1 Verify the Baud Rate 7–3
7.2.2 Disable Diagnostics and Auto Boot 7–3
7.2.3 Obtain the ok Prompt 7–4
7.2.4 Configure an External Display Device 7–4
7.2.5 Run POST 7–6
7.3 POST Output 7–6
7.3.1 post min min 7–7
7.3.2 post min normal 7–7
7.3.3 post min max 7–8
7.3.4 post max min 7–12
7.3.5 post max normal 7–12
7.3.6 post max max 7–13
7.4 Analyzing POST Results 7–18
7.4.1 Error Messages 7–18
7.4.2 Warning Messages 7–20
7.4.3 Info Messages 7–20
8. OpenBoot PROM 8–1
8.1 OpenBoot PROM Utilities 8–1
8.1.1 show-devs Utility 8–2
8.1.2 watch-net Utility 8–2
8.1.3 probe-ide Utility 8–3
To Next Page
Loading...
