Cisco ONS 15454 SDH - Perform a Hairpin Test on a Destination-Node Electrical Port (East to West)

Procedures
iv
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
NTP-D23 Log into the ONS 15454 SDH GUI 3-7
Turn Up a Node 4-1
NTP-D24 Verify Card Installation 4-2
NTP-D30 Create Users and Assign Security 4-4
NTP-D316 Set Up Name, Date, Time, and Contact Information 4-4
NTP-D279 Set Power Monitor Thresholds 4-6
NTP-D169 Set Up CTC Network Access 4-7
NTP-A360 Enable EMS Secure Access 4-8
NTP-D27 Set Up the ONS 15454 SDH for Firewall Access 4-8
NTP-D28 Set Up Timing 4-9
NTP-D170 Create Protection Groups 4-10
NTP-D34 Set Up SNMP 4-12
NTP-D326 Provision OSI 4-14
Turn Up a Network 5-1
NTP-D35 Verify Node Turn-Up 5-2
NTP-D124 Provision a Point-to-Point Network 5-3
NTP-D339 Point-to-Point Network Acceptance Test 5-4
NTP-D38 Provision a Linear ADM Network 5-7
NTP-D340 Linear ADM Network Acceptance Test 5-8
NTP-D40 Provision MS-SPRing Nodes 5-10
NTP-D41 Create the MS-SPRing 5-13
NTP-D341 Two-Fiber MS-SPRing Acceptance Test 5-14
NTP-D342 Four-Fiber MS-SPRing Acceptance Test 5-16
NTP-D304 Provision a Traditional MS-SPRing Dual-Ring Interconnect 5-18
NTP-D305 Provision an Integrated MS-SPRing Dual-Ring Interconnect 5-21
NTP-D44 Provision SNCP Nodes 5-22
NTP-D343 SNCP Acceptance Test 5-24
NTP-D217 Provision a Traditional SNCP Dual-Ring Interconnect 5-26
NTP-D218 Provision an Integrated SNCP Dual-Ring Interconnect 5-28
NTP-D306 Provision a Traditional MS-SPRing/SNCP Dual-Ring Interconnect 5-30
NTP-D307 Provision an Integrated MS-SPRing/SNCP Dual-Ring Interconnect 5-32
NTP-D258 Provision an Open-Ended SNCP 5-34
NTP-D344 Open-Ended SNCP Acceptance Test 5-36
NTP-D46 Subtend an SNCP from an MS-SPRing 5-39
NTP-D47 Subtend an MS-SPRing from an SNCP 5-40