Enterasys SecureStack B3

show multiauth
SecureStack B3 Configuration Guide 20-31
role.Whenapolicyroleisdynamicallyappliedtoaportastheresultofasuccessfully
authenticatedsession,the“authenticatedVLAN”ismapped tothepolicyrolesetintheFilter‐ID
returnedfromtheRADIUSserver.The“authenticatedVLAN”mayeitherbethePVIDoftheport,
ifthe
PVIDOverrideforthepolicyprofileisdisabled,ortheVLANspecifiedinthePVID
OverrideifthePVIDOverrideisenabled.
Commands
show multiauth
Usethiscommandtodisplaymultipleauthenticationsystemconfiguration.
Syntax
show multiauth
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
For information about... Refer to page...
show multiauth 20-31
set multiauth mode 20-32
clear multiauth mode 20-32
set multiauth precedence 20-33
clear multiauth precedence 20-34
show multiauth port 20-34
set multiauth port 20-35
clear multiauth port 20-35
show multiauth station 20-36
show multiauth session 20-36
show multiauth idle-timeout 20-37
set multiauth idle-timeout 20-38
clear multiauth idle-timeout 20-39
show multiauth session-timeout 20-39
set multiauth session-timeout 20-40
clear multiauth session-timeout 20-41