USB on-the-go full-speed/high-speed (OTG_FS/OTG_HS) RM0390
1216/1328 RM0390 Rev 4
1. Initialize and enable channel 1. The application must set the ODDFRM bit in
OTG_HCCHAR1.
2. Write the first packet for channel 1.
3. Along with the last word write of each packet, the OTG_FS/OTG_HS host writes an
entry to the periodic request queue.
4. The OTG_FS/OTG_HS host attempts to send an OUT token in the next (odd) frame.
5. The OTG_FS/OTG_HS host generates an XFRC interrupt as soon as the last packet is
transmitted successfully.
6. In response to the XFRC interrupt, reinitialize the channel for the next transfer.
To Next Page
Loading...
