RM0390 Rev 4 739/1328
RM0390 Fast-mode Plus Inter-integrated circuit (FMPI2C) interface
758
Timeout Error (TIMEOUT)
This section is relevant only when the SMBus feature is supported. Refer to Section 23.3:
FMPI2C implementation.
A timeout error occurs for any of these conditions:
• TIDLE=0 and SCL remained low for the time defined in the TIMEOUTA[11:0] bits: this is
used to detect a SMBus timeout.
• TIDLE=1 and both SDA and SCL remained high for the time defined in the TIMEOUTA
[11:0] bits: this is used to detect a bus idle condition.
• Master cumulative clock low extend time reached the time defined in the
TIMEOUTB[11:0] bits (SMBus t
LOW:MEXT
parameter)
• Slave cumulative clock low extend time reached the time defined in TIMEOUTB[11:0]
bits (SMBus t
LOW:SEXT
parameter)
When a timeout violation is detected in master mode, a STOP condition is automatically
sent.
When a timeout violation is detected in slave mode, SDA and SCL lines are automatically
released.
When a timeout error is detected, the TIMEOUT flag is set in the FMPI2C_ISR register, and
an interrupt is generated if the ERRIE bit is set in the FMPI2C_CR1 register.
Alert (ALERT)
This section is relevant only when the SMBus feature is supported. Refer to Section 23.3:
FMPI2C implementation.
The ALERT flag is set when the FMPI2C interface is configured as a Host (SMBHEN=1),
the alert pin detection is enabled (ALERTEN=1) and a falling edge is detected on the SMBA
pin. An interrupt is generated if the ERRIE bit is set in the FMPI2C_CR1 register.
23.4.15 DMA requests
Transmission using DMA
DMA (Direct Memory Access) can be enabled for transmission by setting the TXDMAEN bit
in the FMPI2C_CR1 register. Data is loaded from an SRAM area configured using the DMA
peripheral (see Section 9: Direct memory access controller (DMA) on page 203) to the
FMPI2C_TXDR register whenever the TXIS bit is set.
Only the data are transferred with DMA.
• In master mode: the initialization, the slave address, direction, number of bytes and
START bit are programmed by software (the transmitted slave address cannot be
transferred with DMA). When all data are transferred using DMA, the DMA must be
To Next Page
Loading...
Need help?
General
