RM0390 Rev 4 1273/1328
RM0390 HDMI-CEC controller (HDMI-CEC)
1283
32.5.6 Transmission Error Detection (TXERR)
The CEC initiator sets the TXERR flag if detecting low impedance on the CEC line when it is
transmitting high impedance and is not expecting a follower asserted bit. TXERR flag also
generates a CEC interrupt if the TXERRIE=1.
TXERR assertion stops the message transmission. Application is in charge to retry the
failed transmission up to 5 times.
TXERR checks are performed differently depending on the different states of the CEC line
and on the RX tolerance configuration.
Figure 441. TXERR detection
Table 234. TXERR timing parameters
Time RXTOL ms Description
T
s
x 0 Bit start event.
T
1
10.3
The earliest time for a low - high transition when
indicating a logical 1.
00.4
T
n1
x0.6
The nominal time for a low - high transition when
indicating a logical 1.
T
2
00.8
The latest time for a low - high transition when
indicating a logical 1.
10.9
T
ns
x 1.05 Nominal sampling time.
T
3
11.2
The earliest time a device is permitted return to a
high impedance state (logical 0).
01.3
7
V
7
7
Q
7
7
7
Q
7
7
7
QI
7
7
QV
7[DUELWUDWLRQELW
7[GDWDELW
7[DUELWUDWLRQELW
7[GDWDELW
7[DFNQRZOHGJH
069
7;(55&KHFNLQJ:LQGRZ 7ROHUDQFHPDUJLQV
/HJHQG
&(&LQLWLDWRUELWWLPLQJ
To Next Page
Loading...
Need help?
General
