Direct memory access controller (DMA) RM0390
204/1328 RM0390 Rev 4
– DMA flow controller: the number of data items to be transferred is software-
programmable from 1 to 65535
– Peripheral flow controller: the number of data items to be transferred is unknown
and controlled by the source or the destination peripheral that signals the end of
the transfer by hardware
• Independent source and destination transfer width (byte, half-word, word): when the
data widths of the source and destination are not equal, the DMA automatically
packs/unpacks the necessary transfers to optimize the bandwidth. This feature is only
available in FIFO mode
• Incrementing or non-incrementing addressing for source and destination
• Supports incremental burst transfers of 4, 8 or 16 beats. The size of the burst is
software-configurable, usually equal to half the FIFO size of the peripheral
• Each stream supports circular buffer management
• 5 event flags (DMA half transfer, DMA transfer complete, DMA transfer error, DMA
FIFO error, direct mode error) logically ORed together in a single interrupt request for
each stream
To Next Page
Loading...
Need help?
General
