RM0453 Rev 1 579/1461
RM0453 Analog-to-digital converter (ADC)
592
Bit 2 SCANDIR: Scan sequence direction
This bit is set and cleared by software to select the direction in which the channels is scanned
in the sequence. It is effective only if CHSELMOD bit is cleared to 0.
0: Upward scan (from CHSEL0 to CHSEL17)
1: Backward scan (from CHSEL17 to CHSEL0)
Note: The software is allowed to write this bit only when ADSTART bit is cleared to 0 (this
ensures that no conversion is ongoing).
If CCRDY is not yet asserted after channel configuration (writing ADC_CHSELR register
or changing CHSELRMOD or SCANDIR), the value written to this bit is ignored.
Bit 1 DMACFG: Direct memory access configuration
This bit is set and cleared by software to select between two DMA modes of operation and is
effective only when DMAEN = 1.
0: DMA one shot mode selected
1: DMA circular mode selected
For more details, refer to Section 18.5.5: Managing converted data using the DMA on
page 554
Note: The software is allowed to write this bit only when ADSTART bit is cleared to 0 (this
ensures that no conversion is ongoing).
Bit 0 DMAEN: Direct memory access enable
This bit is set and cleared by software to enable the generation of DMA requests. This allows
the DMA controller to be used to manage automatically the converted data. For more details,
refer to Section 18.5.5: Managing converted data using the DMA on page 554.
0: DMA disabled
1: DMA enabled
Note: The software is allowed to write this bit only when ADSTART bit is cleared to 0 (this
ensures that no conversion is ongoing).
To Next Page
Loading...
Need help?
General
