Sun Microsystems Blade 1500 - Page 194

9-8 Sun Blade 1500 Service, Diagnostics, and Troubleshooting Manual • December 2004
DIMM memory test1 8. Click the plus sign adjacent to Memory.
9. Select kmem(vmemtest).
10.Click Reset.
11.Click Start.
12 seconds
DIMM memory test2 8. Click the plus sign adjacent to Memory.
9. Select mem(pmemtest).
10.Click Reset.
11.Click Start.
10 seconds
Flash PROM 8. Click the plus sign adjacent to Memory.
9. Select seeprom0(seepromtest).
10.Click Reset.
11.Click Start.
9 seconds
DIMM0 PROM 8. Click the plus sign adjacent to Memory.
9. Select seeprom1(seepromtest).
10.Click Reset.
11.Click Start.
5 seconds
DIMM1 PROM 8. Click the plus sign adjacent to Memory.
9. Select seeprom2(seepromtest).
10.Click Reset.
11.Click Start.
5 seconds
DIMM2 PROM 8. Click the plus sign adjacent to Memory.
9. Select seeprom3(seepromtest).
10.Click Reset.
11.Click Start.
5 seconds
DIMM3 PROM 8. Click the plus sign adjacent to Memory.
9. Select seeprom4(seepromtest).
10.Click Reset.
11.Click Start.
5 seconds
Graphics
accelerators
8. Select Graphics.
9. Click Reset.
10.Click Start.
Note: Because the GUI is using the graphics accelerator while
SunVTS is testing it, errors might be reported. These errors are
ignored.
85 seconds
TABLE 9-2 Steps to Test Components in Functional Mode (Continued)
Component Steps to Take
Approximate
Time for 1 Pass