Sun Microsystems Blade 1500 - Page 195

Chapter 9 SunVTS 9-9
Smart card reader 8. From Select Devices, check Intervention.
9. Click the plus sign adjacent to Other Devices.
10.Select scmi2c0(sc2test)
11.Right click, select Test Parameter Options.
12.Click all enable buttons.
13.From Within Instance, select Apply.
14.Insert a known good smart card.
15.Click Reset.
16.Click Start.
7 seconds
Network 8. From Select Devices, check Intervention.
9. Select Network.
10.Click Reset.
11.Click Start.
17 seconds
Serial ports 8. From Select Devices, check Intervention.
9. Click the plus sign adjacent to Comm.Ports.
10.Select su0(sutest).
11.Right click, select Test Parameter Options.
12.For Test_Type, select a_b.
13.For Loopback_Type, select Internal_a_to_a__b_to_b.
14.From Within Instance, select Apply.
15.Click Reset.
16.Click Start.
11 seconds
Parallel port 8. Click the plus sign adjacent to Other Devices.
9. Select ecpp0(ecpptest).
10.Click Reset.
11.Click Start.
10 seconds
Speaker 8. Click the plus sign adjacent to Other Devices.
9. Select sound0(audiotest).
10.Click Reset.
11.Click Start.
45 seconds
System sensors Testing is not possible in functional mode.
CPU 8. Select Processor
9. Click Reset.
10.Click Start.
1000+ seconds
Note: This
test is stopped
by clicking
Stop.
TABLE 9-2 Steps to Test Components in Functional Mode (Continued)
Component Steps to Take
Approximate
Time for 1 Pass