(b) Position the gasket [2] on the side of the QAD adapter that mates up with the gearbox
pad. Make sure the hole pattern of the gasket [2] aligns with the hole pattern of the QAD
adapter [1].
NOTE: If applicable, remove sheet covering the gasket to bond on the QAD and gearbox
pad.
(c) Apply a thin layer of Never-Seez NSBT compound, D00006, to the twelve flathead
screws [3].
(d) Position the QAD adapter [1] to the gearbox mounting pad.
NOTE: Be sure the QAD coupling is in the correct position (Figure 401).
(e) Install the twelve flathead screws [3].
(f) Tighten the screws [3] to 287 ±13 in-lb (32 ±2 N·m).
SUBTASK 24-11-61-410-001
(2) Install the IDG. To install the IDG, do this task: Integrated Drive Generator (IDG) Installation,
TASK 24-11-11-400-801.
H. Put the Airplane Back to Its Usual Condition
SUBTASK 24-11-61-410-002
(1) Do this task: Close the Fan Cowl Panels, TASK 71-11-02-410-801-F00.
END OF TASK
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
24-11-61
Page 407
D633A101-ILF Jun 15/2019
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL
To Next Page
Loading...
