B. Consumable Materials
Reference Description Specification
B00083 Solvent - VM&P Naphthas TT-N-95 Type II, ASTM
D-3735 Type III
C00259 Coating - Chemical And Solvent Resistant
Finish, Corrosion Inhibiting Primer
BMS10-11 Type I
G00291 Tape - Aluminum Foil, Scotch 425 AMS-T-23397 / L-T-80
C. Location Zones
Zone Area
111 Radome
D. Procedure
SUBTASK 53-52-31-110-001
(1) Clean the nose radome surface where you will install the director bar with solvent, B00083.
SUBTASK 53-52-31-370-001
(2) Apply one layer of the primer, C00259 to the surface where you will install the director bar.
SUBTASK 53-52-31-110-002
(3) Clean the surface with the solvent, B00083.
SUBTASK 53-52-31-420-001
(4) Do these steps to make and install the director bar.
(a) Cut a 14 in. (36 cm) long strip of the Scotch 425 Aluminum Foil Tape, G00291.
(b) Install the tape as shown in (Figure 401).
(c) Push the Scotch 425 Aluminum Foil Tape, G00291 correctly into its location.
SUBTASK 53-52-31-420-002
(5) Install the M1458 decal on the radome as shown in (Figure 401) if it is not installed.
SUBTASK 53-52-31-410-001
(6) Do this task: (Nose Radome Installation, TASK 53-52-00-400-801).
SUBTASK 53-52-31-860-002
(7) Remove the safety tag and close this circuit breaker:
F/O Electrical System Panel, P6-1
Row Col Number Name
D 13 C00120 WEATHER RADAR RT
END OF TASK
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
53-52-31
Page 402
D633A101-ILF Jun 15/2018
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL
To Next Page
Loading...
