SUBTASK 76-11-01-020-011-F00
(10) For engine 1, remove the lever assembly [141] as follows:
CAUTION
BE CAREFUL WHEN YOU INSERT THE DOWEL. IF THE NINE WASHERS
DO NOT STAY IN THEIR CORRECT POSITION, DAMAGE CAN OCCUR.
(a) Put the dowel set, SPL-2409 against the right side end of the long control shaft [146].
(b) Hit lightly (carefully tap) on the dowel.
NOTE: This is to move the long control shaft off the control levers.
1) Move the dowel until the thrust lever assembly [141] is on the dowel.
NOTE: Do not move the long control shaft [146] from the position it is now in. More
movement will let the start lever falls.
(c) Hold the thrust lever and move the dowel from the lever.
1) Stop the dowel movement when you can lift up the lever.
2) Make sure that the washers [145] are still held by the dowel.
(d) Remove the thrust lever assembly [141] through the top of the control stand.
(e) Remove the two washers [145] between the thrust levers if you will remove thrust lever
assembly [142] for engine 2.
NOTE: Make sure that the washers do not fall into the control stand.
NOTE: Do not move the dowel from the position it is in unless you want to remove thrust
lever assembly [142] for engine 2.
SUBTASK 76-11-01-020-012-F00
(11) For engine 2, remove the thrust lever assembly [142] as follows:
CAUTION
BE CAREFUL WHEN YOU INSERT THE DOWEL. IF THE NINE WASHERS
DO NOT STAY IN THEIR CORRECT POSITION, DAMAGE CAN OCCUR.
(a) Put the dowel set, SPL-2409 against the right side end of the long control shaft [146].
(b) Hit lightly (carefully tap) on the dowel.
NOTE: This is to move the long control shaft off the thrust lever.
1) Move the dowel until the thrust lever assembly [142] is on the dowel.
NOTE: Do not move the long control shaft from the position it is now in. More
movement will let the thrust lever for engine 1 falls.
(c) Hold the thrust lever assembly [142] and move the dowel from the lever.
1) Stop the dowel movement when you can lift up the lever.
(d) Make sure the washers [145] are still held on the long control shaft [146].
(e) Remove the thrust lever assembly [142] through the top of the control stand.
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
CFM56 ENGINES (CFM56-7)
76-11-01
Page 407
D633A101-ILF Oct 15/2018
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL
To Next Page
Loading...
