EasyManua.ls Logo

Boeing 737-600 - Subtask 24-21-71-410-001; Subtask 24-21-71-700-001; Subtask 24-21-71-700-002; Subtask 24-21-71-700-003

Boeing 737-600
2300 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ILF 401, 406, 409, 410, 412, 416 PRE SB 737-24-1128 (Continued)
(b) Loosen the screws one full turn, then tighten the screws to 25 ±1 in-lb (3 ±0 N·m).
ILF ALL
SUBTASK 24-21-71-410-001
(5) Install the applicable forward bulkhead liner.
G. The Installation Test of the Current Transformer
SUBTASK 24-21-71-700-001
(1) If you replaced the GEN 1 DPCT, T374 or GEN 2 DPCT, T375 do this test:
(a) Start the applicable engine, do this task: Start the Engine Procedure (Selection),
TASK 71-00-00-800-807-F00.
(b) Make sure the applicable GEN OFF BUS light on the P5-4 panel is on.
(c) Set the applicable GEN control switch on the P5-4 panel to the ON position.
(d) Make sure the applicable GEN OFF BUS light on the P5-4 panel goes off.
(e) Stop the engine, do this task: Stop the Engine Procedure (Usual Engine Stop),
TASK 71-00-00-700-819-F00.
SUBTASK 24-21-71-700-002
(2) If you replaced the EXT PWR CT, T378 do this test:
(a) Make sure the BAT switch on the P5-13 panel is in the ON position.
(b) Set the BUS TRANS switch on the P5-4 panel to the AUTO position.
(c) Make sure both TRANSFER BUS OFF lights on the P5-4 panel are on.
(d) Connect external power to the P19 panel.
(e) Make sure the GRD POWER AVAILABLE light on the P5-4 panel is on.
(f) Set the GRD PWR switch on the P5-4 panel to the ON position.
(g) Make sure both TRANSFER BUS OFF lights on the P5-4 panel go OFF.
(h) Do this task: Remove External Power, TASK 24-22-00-860-814.
SUBTASK 24-21-71-700-003
(3) If you replaced the APU DPCT, T376 do this test:
(a) Do this task: APU Starting and Operation, TASK 49-11-00-860-801.
(b) Make sure the APU GEN OFF BUS light on the P5-4 panel comes on (approximately 50
seconds) after APU start.
(c) Set either of the APU GEN switches on the P5-4 panel to the ON position.
(d) Make sure the APU GEN OFF BUS light on the P5-4 panel goes off.
(e) Do this task: Remove APU Generator Power, TASK 24-22-00-860-816.
H. Put the airplane in its usual condition.
SUBTASK 24-21-71-860-003
(1) Do this task: Remove Electrical Power, TASK 24-22-00-860-812.
END OF TASK
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
24-21-71
Page 416
D633A101-ILF Oct 15/2019
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL

Table of Contents

Related product manuals