Boeing 737-600 - Subject 76-11-03 - CONTROL STAND LIGHTPLATES, SEALS, SPACERS, AND RETAINERS, COVERS AND STOPS; Pageblock 76-11-03;401 - CONTROL STAND LIGHTPLATES, SEALS, SPACERS, AND RETAINERS, COVERS AND STOPS - REMOVAL;INSTALLATION; Task 76-11-03-000-801-F00 - Control Stand Lightplate Removal; Subtask 76-11-03-860-001-F00

CONTROL STAND LIGHTPLATES, SEALS, SPACERS, AND RETAINERS, COVERS AND STOPS -
REMOVAL/INSTALLATION
1. General
A. This procedure has these tasks:
(1) Control Stand Lightplate Removal
(2) Control Stand Lightplate Installation
(3) Control Stand Seals, Spacers and Retainers Removal
(4) Control Stand Seals, Spacers and Retainers Installation
(5) Control Stand Covers and Stops Removal
(6) Control Stand Covers and Stops Installation.
TASK 76-11-03-000-801-F00
2. Control Stand Lightplate Removal
(Figure 401)
A. General
(1) This task provides the instructions on how to remove a lightplate from the control stand.
B. References
Reference Title
27-51-00-040-801 Trailing Edge Flap System Deactivation (P/B 201)
C. Location Zones
Zone Area
211 Flight Compartment - Left
212 Flight Compartment - Right
D. Prepare for the Removal
SUBTASK 76-11-03-860-001-F00
WARNING
DO THE DEACTIVATION PROCEDURE FOR THE TRAILING EDGE FLAP
BEFORE YOU DO WORK ON THE FLAP SYSTEM. THE FLAPS MOVE
QUICKLY. THEY CAN CAUSE INJURIES TO PERSONNEL, AND DAMAGE TO
EQUIPMENT.
(1) Do this task: Trailing Edge Flap System Deactivation, TASK 27-51-00-040-801.
SUBTASK 76-11-03-860-002-F00
(2) Make sure that the left and right engine start switches are in off and install a
DO-NOT-OPERATE tag.
ILF 301, 304, 308, 310, 314, 315, 317-319, 323, 331-399, 533, 535, 537, 562; AIRPLANES WITH
AUTO-IGNITION
(a) This is the AUTO position.
ILF ALL
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
CFM56 ENGINES (CFM56-7)
76-11-03
Page 401
D633A101-ILF Feb 15/2019
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL