NOSE RADOME - CLEANING/PAINTING
1. General
A. This procedure contains these tasks:
(1) Nose Radome Cleaning/Painting.
NOTE: A nose radome protective boot can be used in place of the BMS 10-60, Type II,
enamel coating, C50075. The finish sequence prior to applying the protective boot can
be found in TASK 53-52-00-370-801, Paragraph G. If a protective boot is not being
installed, finish the radome per TASK 53-52-00-370-801, Paragraph F.
TASK 53-52-00-370-801
2. Nose Radome - Cleaning/Painting
A. References
Reference Title
51-21-11 P/B 701 PAINT STRIPPING - CLEANING/PAINTING
51-21-21-100-802 Cleaning and Preparation of Internal and External Plastic
Surfaces (P/B 701)
51-21-71-370-802 Apply BMS 10-21 Type II Conductive Coating To Specified
External Surfaces (P/B 701)
51-21-71-370-803 Apply BMS 10-21 Type IV Conductive Coating To Specified
External Surfaces (P/B 701)
51-21-72-370-802 BMS10-103, Type 1, Primer - Application (P/B 701)
51-21-73-370-803 BMS10-60 Topcoat Application (P/B 701)
51-21-99-300-801 Decorative Exterior Paint System Application (P/B 701)
53-52-00-400-802 Nose Radome Protective Boot Installation (P/B 201)
53-52-03-000-801 Remove the Lightning Diverter Strips (P/B 201)
53-52-03-400-801 Install the Lightning Diverter Strip (P/B 201)
B. Tools/Equipment
NOTE: When more than one tool part number is listed under the same "Reference" number, the
tools shown are alternates to each other within the same airplane series. Tool part numbers
that are replaced or non-procurable are preceded by "Opt:", which stands for Optional.
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
53-52-00
Page 701
D633A101-ILF Oct 15/2017
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL
To Next Page
Loading...
