(b) If you find a fault code, then do these steps:
1) Go to the Fault Code Index in the applicable chapter of the FIM and find the fault
code.
NOTE: The first two digits of the fault code is the FIM chapter.
2) Find the task number on the same line as the fault code.
3) Go to the task in the FIM and do the steps in the task.
(c) If you find a description of the fault, then do these steps:
1) Go to the Observed Fault List at the beginning of the FIM and find the best
description for the fault.
2) Find the task number on the same line as the fault description.
3) Go to the task in the FIM and do the steps in the task.
SUBTASK 30-00-00-440-005
(2) If the fault was repaired, remove the INOP placard from the affected light.
END OF TASK
TASK 30-00-00-040-806
10. MMEL 30-13 (DDPG) Preparation - Windshield Wiper System Inoperative
A. General
(1) This task gives the maintenance steps which prepare the airplane for flight with windshield
wiper systems inoperative.
NOTE: This maintenance procedure is optional.
B. References
Reference Title
30-42-31-000-801 Windshield Wiper Arm Removal (P/B 201)
30-42-31-400-801 Windshield Wiper Arm Installation (P/B 201)
C. Location Zones
Zone Area
200 Upper Half of Fuselage
D. Procedure
SUBTASK 30-00-00-930-008
(1) Put an INOP placard on the wiper switch.
SUBTASK 30-00-00-020-005
(2) If the wiper blade obstructs forward vision do these steps:
(a) Do this task: Windshield Wiper Arm Removal, TASK 30-42-31-000-801.
(b) Do this task: Windshield Wiper Arm Installation, TASK 30-42-31-400-801.
NOTE: It is only necessary to put the wiper arm in the parked position and to apply the
appropriate downward force on the wiper blade. The steps related to the sweep
of the wiper arm are not necessary.
END OF TASK
737-600/700/800/900
AIRCRAFT MAINTENANCE MANUAL
30-00-00
Page 921
D633A101-ILF Feb 15/2018
ECCN 9E991 BOEING PROPRIETARY - Copyright © Unpublished Work - See title page for details
EFFECTIVITY
ILF ALL
To Next Page
Loading...
