D-Link xStack DGS-3610 Series - Configuring Layer 2 Interface as Promiscuous Port of Private VLAN

DGS-3610 Series Configuration Guide Chapter 11 Private VLAN Configuration
11-5
For example:
DGS-3610# configure terminal
DGS-3610(config)# interface gigabitEthernet 0/2
DGS-3610(config-if)# switchport mode private-vlan host
DGS-3610(config-if)# switchport private-vlan host-association
202 203
DGS-3610(config-if)# end
DGS-3610#
Note
Primary VLAN and Secondary VLAN in this process are associated.
11.2.6 Configuring Layer 2 Interface as
Promiscuous Port of Private VLAN
To configure the layer 2 interface as the port of private VLAN, use the following commands:
Command
Description
configure terminal
Enter configuration mode
interface <interface>
Enter the interface configuration mode.
Megabit, Gigabit, 10 Gigabit
switchport mode private-vlan
promiscuous
Configure as the layer 2 switching mode of private
VLAN
no switchport mode
Delete the private VLAN configuration for the port
switchport private-vlan mapping
p_vid{svlist | add svlist | remove svlist}
Select the VLAN where the promiscuous port of the
private VLAN is located and mixed secondary VLAN
list
no switchport private-vlan mapping
Cancel all promiscuous secondary VLANs.
Following example to describe how to configure:
DGS-3610# configure terminal
DGS-3610(config)# interface gigabitEthernet 0/2
DGS-3610(config-if)# switchport mode private-vlan promiscuous
DGS-3610(config-if)# switchport private-vlan mapping 202 add 203
DGS-3610(config-if)# end
Note
Primary VLAN and Secondary VLAN in this process are associated.