D-Link xStack DGS-3610 Series - Configuring Cos-Map

DGS-3610 Series Configuration Guide Chapter 45 QOS Configuration
45-11
45.2.9 Configuring Cos-Map
You may set cos-map to select the queue the output packets enter. The default value of
cos-map is provided in the default QoS configuration section.
Command
Description
configure terminal
Enter the configuration mode
priority-queue Cos-Map qid
cos0 [cos1 [cos2 [cos3 [cos4
[cos5 [cos6 [cos7]]]]]]]
qid is the queue id; cos0..cos7 are the CoS values
associated with that queue.
no priority-queue cos-map
Restore default of cos-map
Below is the example of configuring CoS Map
DGS-3610# configure terminal
DGS-3610(config)# priority-queue Cos-Map 1 2 4 6 7 5
DGS-3610(config)# end
DGS-3610# show mls qos queuing
Cos-queue map:
cos qid
--- ---
0 1
1 2
2 1
3 4
4 1
5 1
6 1
7 1
wrr bandwidth weights:
qid weights
--- -------
0 1
1 2
2 3
3 4
4 5
5 6
6 7
7 8