D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 37 Configuration of 802.1X
37-15
37.2.8 Setting the Packet Retransmission
Interval
After the device sends the EAP-request/identity, it resends that message if no response is
received from the user within a certain period. By default, this value is 3 seconds. You should
modify this value to suit the specific network size.
In the privileged mode, you can set the packet retransmission interval through the following
steps:
Command
Function
configure terminal
Enter the global configuration mode.
dot1x timeout tx-period seconds
Setting the Packet Retransmission Interval
end
Return to the privileged mode.
write
Save the configuration.
show dot1x
Show the dot1x configurations.
You can use the no dot1x timeout tx-period to restore the packet re-transmission interval
to its default. The following example sets the packet retransmission interval to 100 seconds:
DGS-3610# configure terminal
DGS-3610(config)# dot1x timeout tx-period 100
DGS-3610(config)# end
37.2.9 Setting the Maximum Number of
Requests
If the device does not receive response within the ServerTimeout after it sends an
authentication request to the Radius Server, it will retransmit the packets.The maximum
number of requests indicates the maximum retransmission requests of the device.The
authentication fails if this number is exceeded. By default, this value is 3. You should modify
this value to suit the specific network size.
In the privileged mode, you can set the maximum number of retransmissions through the
following steps:
Command
Function
configure terminal
Enter the global configuration mode.
dot1x max-req count
Set the maximum number of packet
re-transmissions.
end
Return to the privileged mode.
write
Save the configuration.
show dot1x
Show the dot1x configurations.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English