D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 25 SNMP Configuration
25-13
25.3.3 Viewing SNMP User
To view the SNMP users configured on the current agent, run the command show snmp
user in the privileged user mode:
DGS-3610# show snmp user
User name: test
Engine ID: 8000131103000000000000
storage-type: permanent active
Security level: auth priv
Auth protocol: SHA
Priv protocol: DES
Group-name: g1
25.3.4 Viewing SNMP View and Group
To view the group configured on the current agent, run the command show snmp group in
the privileged user mode:
DGS-3610# show snmp group
groupname: g1
securityModel: v3
securityLevel:authPriv
readview: default
writeview: default
notifyview:
groupname: public
securityModel: v1
securityLevel:noAuthNoPriv
readview: default
writeview: default
notifyview:
groupname: public
securityModel: v2c
securityLevel:noAuthNoPriv
readview: default
writeview: default
notifyview:
To view the view configured on the current agent, run the command show snmp view in the
privileged user mode:
DGS-3610# show snmp view
default(include) 1.3.6.1
test-view(include) 1.3.6.1.2.1
25.4 SNMP Configuration Example
 Configuration requirement
In the figure, the router is connected with the network management station (NMS) via the
Ethernet. The IP addresses of NMS and the router are 192.168.12.181 and 192.168.12.1

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English