D-Link xStack DGS-3610 Series User Manual

Chapter 2 Configuration of Switch Basic Management DGS-3610 Series Configuration Guide
2-10
be the default command prompt (if the system name exceeded to more than 32 characters,
the first 32 characters will be intercepted and taked as the system prompt). The prompt will
be changed with the system name. By default, the concrete device name will be taken as the
system name, for example ―DGS-3610-26‖ and ―DGS-3610-26G".
2.6.2 Configuring a System Name
Our products provide the following commands to configure the system name in global
configuration mode:
Command
Function
DGS-3610(Config)# hostname name
Configure a system name. The name must be consisted
by the characters to be printed, and the length is not up to
255 byte.
To restore the system name to the default value, use the no hostname command in the
global configuration mode. The following example shows how to changes the device name
to DGS-3610 series:
DGS-3610# configure terminal //Enter to the global configuration mode.
DGS-3610(config)# hostname DGS-3610 //Set the network device name to D-Link
D-Link(config)# //The name has been modified successfully.
2.6.3 Configuring a Command Prompt
If you have not configured a command prompt, the system prompt will be taken as the
default prompt (if the length of the system name exceeded up to 32 characters, the first 32
characters will be intercepted and be taken as the default prompt). The prompt is changed
with the change of the system name. You can use the prompt command to configure the
command prompt in the global configuration mode, and the command prompt is only valid
for the EXEC mode.
Command
Function
DGS-3610# prompt string
Set the command prompt.The name must be consisted by
the characters to be printed. If the length of the name
exceeds 32 characters, intercept the first 32 characters.
To restore to the default prompt, use the no prompt command in the global configuration
mode.
2.7 Banner Configuration
2.7.1 Overview
When the user logs in to the switch, you may need to notify the users some required
information. You can achieve the purpos by setting a banner. You can create two-type

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English