D-Link xStack DGS-3610 Series

Chapter 35 IP Multicast Routing Configuration DGS-3610 Series Configuration Guide
35-22
igmp last member query counter is 7
igmp last member query interval is 255 1/10seconds
igmp has 5 different config in this interface
igmp nif learnt mem num is 0
igmp nif limit num is 1024
igmp other querier interval is 255
igmp querier ip is 192.11.11.11
igmp query response interval is 100 1/10seconds
igmp router robustness is 2
igmp special query num is 0
igmp version is 3
IGMP is enabled on interface
35.6.18 Show the Configuration Information
of IGMP SSM-MAP
To show the configuration information of IGMP SSM-MAP, execute the following command in
the user mode:
Command
Function
DGS-3610# show ip igmp ssm- mapping
Show the Configuration Information of IGMP
SSM-MAP.
DGS-3610# show ip igmp ssm- mapping
233.3.3.3
Shown the mapping information from IGMP SSM-MAP
to group 233.3.3.3.
35.6.19 Show Enabled Condition of IGMP
Debugging Switch
To show the enabled condition of the IGMP debugging switch, execute the following
command in the privilege mode:
Command
Function
DGS-3610# show debugging
Show the enabled condition of the IGMP debugging
switch.
35.6.20 IGMP debug switch
To turn on IGMP debug switch and check the IGMP behavior, execute the following
command in the privileged mode:
Command
Function
DGS-3610# debug ip igmp all
Turn on all IGMP debug switches
DGS-3610# debug ip igmp decode
Turn on IGMP debug decode switch
DGS-3610# debug ip igmp encode
Turn on IGMP debug encode switch
DGS-3610# debug ip igmp events
Turn on IGMP debug event switch