DGS-3610 Series Configuration Guide Chapter 27 RIP Routing Protocol Configuration
27.2.8 Configuring the RIP Route Source
Address Validation
By default, the RIP will validate the source addresses of the incoming route update packets.
If the source address of a packet is invalid, the RIP will discard that packet. Determining the
validity of the source address is determine if the source IP address is on the same network
as the IP address of the interface. No validation will be performed if the IP address interface
is not numbered.
To configure route source address validation, execute the following commands in the RIP
routing process configuration mode:
DGS-3610(config-router)# no
validate-update-source
Disable source address validation
DGS-3610(config-router)#
validate-update-source
Enable source address validation
27.2.9 Control of RIP interface status
In some condition, it is necessary to configure the RIP operation flexibly. If you only hope the
device to learn the RIP route, but not carry out the RIP route notification, you can configure
the passive interface. Or, if you hope to configure the status of some interface individually,
you can use the command to control the sending or receiving of the RIP message for
specified interface by using the command.
To configure some interface as the passive mode, execute the following command in the RIP
route process configuration mode:
DGS-3610(config-router)# passive-interface
{default |
interface-type interface-num}
Configure the passive interface.
DGS-3610(config-router)#no passive-interface
{default
| interface-type interface-num}
Cancel the passive interface.
After the passive interface receives the RIP request, it will not carry out the
response. However, after it receives the non RIP (such as the route
diagnosis program) request, it will carry out the message, for these
request programs hope to understand the route condition of all devices.
To Next Page
Loading...
Need help?
General