DGS-3610(config)# show ip igmp snooping gda
Abbr: M - mrouter
D - dynamic
S - static
VLAN Address Member ports
---- -------------- -----------------------------
1 224.1.1.1 GigabitEthernet 0/7(S)
15.2.16 Configuration IGMP Filtering
In some cases, you may need to make a certain port receive only a special batch of
multicast data flows, and control the maximum number of groups permitted to be
dynamically added under this port. IGMP Filtering meets this requirement.
You can apply one IGMP Profile to a port. If the port receives the IGMP Report packet, the
switch will check if the multicast address the port wants to join is within the range of IGMP
Profile. If yes, it is allowed to join, with subsequent processing performed later.
You can also configure the maximum number of groups to be added on one port. When it is
beyond the range, the switch will no longer receive, or handle the IGMP Report packet.
In the configuration mode, set IGMP Filtering by performing the following steps:
15.3 Viewing IGMP Snooping
Information
Related to the information of IGMP snooping, please refer to the following information:
Viewing Current Mode
Viewing and Clearing IGMP snooping Statistics
Viewing Router Interface Information
Viewing Dynamic Forwarding Table
Viewing Source Port Check Status
Viewing IGMP Profile
Viewing IGMP Filtering