D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 40 CPU Protection Configuration
40-3
Type
Default maximum bandwidth (pps)
Default priority
DHCP_OPTION82
128
0
UDP_HELPER
128
0
Through the command no cpu-protected type, the maximum bandwidth and priority setting
of the packet can be reset to the default value. The default maximum bandwidth is 1000pps,
priority is 0.
40.2.2 Configuring the Bandwidth for Each
Type of Packets
In the configuration mode, configure the queue of each type of packets through the following
steps:
Command
Function
DGS-3610(config)# cpu-protect type {arp |
bpdu | dhcp | ipv6mc | igmp | rip | ospf
| vrrp | pim | err-ttl | unknown-ipmc |
dvmrp} pps pps_vaule
Set the queue for the packets in PPS, which is
an integer.
DGS-3610# end
Return to the privileged mode.
This example shows the profile configuration process:
DGS-3610(config)#cpu-protect type bpdu pps 200
Set packet type bpdu pps 100.
40.2.3 Configuring the Priority for Each
Type of Packets
In the configuration mode, configure the queue of each type of packets through the following
steps:
Command
Function
DGS-3610(config)# cpu-protec type {arp |
bpdu | dhcp | ipv6mc | igmp | rip | ospf |
vrrp | pim | err-ttl | unknown-ipmc} pri
pri_vaule
Set the queue for the packets in PPS, which is
an integer.
DGS-3610# end
Return to the privileged mode.
This example shows the profile configuration process:
DGS-3610(config)# cpu-protect type bpdu pri 7
Set packet type bpdu priority 7.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English