DGS-3610 Series Configuration Guide Chapter 51 POE Management Configuration
In the Auto mode, the power is allocated according to the detected port PD type. In the Auto
mode, the equipment allocates power to classes 1~3 PD devices as follows: class1~4W,
class2~7W, lass3~15.4W and class0~15.4W.
This configuration is automatically performed by the switch without any user intervention.
51.2.6 Disconnection Detection Mode
The equipment supporting POE checks whether a previously connected device has been
disconnected through disconnection detection. The equipment supports two detection
modes: AC and DC. In the AC detection mode, the connected PD device is disconnected
when the current of a port is smaller than a fixed value for the specified period. The DC
detection mode works by detecting the voltage feature of the port.
You can execute the following command to set the disconnection detection mode. Please
make the following configuration in the global mode. You can also set this mode for a
particular device.
Table 51-5 Disconnecting Detection Mode
Enter the configuration mode
poe disconnect-mode {ac | dc} |
no poe disconnect-mode
Set the disconnect detection mode/restore the disconnect
detection mode to the default value
Return to privileged EXEC mode
Verify the configuration of the steps above
copy running-config
startup-config
Save the settings into the parameter file.
By default, the disconnection detection mode is the AC mode.
For example, set the disconnectiong detection mode to DC:
DGS-3610#
DGS-3610# configure
DGS-3610(config)# poe-disconnect-mode dc
DGS-3610(config-if)# end
DGS-3610#
51.2.7 Showing the Power Supply Status of
the Port/System
The equipment supporting POE will scan the ports and the status of the entire POE system
periodically, and save all the status information. You can view interface status by executing
the show command in the privileged EXEC mode.
To Next Page
Loading...
Need help?
General