D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 7 Aggregate Port Configuration
7-5
7.2.5 Configuring Traffic Balancing of
Aggregate Port
In the configuration mode, configure the traffic balancing for the AP by performing the
following steps:
Command
Function
DGS-3610(config)#
aggregateport load-balance
{dst-mac |
src-mac | src-dst-mac |
dst-ip | src-ip | ip }
Set the AP traffic balancing and select the algorithm to be used:
dst-mac: Traffic is distributed according to the destination MAC
addresses of the input packets. In various AP links, the packets
with the same destination MAC address are sent to the same
member link, and those with different destination MAC
addresses are allocated to different member links.
src-mac: Traffic is distributed according to the source MAC
addresses of the incput packets. In various AP links, the packets
from different MAC addresses are allocated to different member
links, and those from the same MAC addresses use the same
member links.
ip: Traffic is distributed according to the source IP and
destination IP. Packets with different source- destination IP
addresses are forwarded to different member links. The packets
with the same source-destination IP addresses are forwarded
from the same member link.
dst-ip: Traffic is distributed according to the destination MAC
addresses of the incoming packets. In various AP links, the
packets with the same destination IP address are sent to the
same member link, and those with different destination IP
addresses are allocated to different member links.
src-mac: The traffic is allocated according to the source MAC
addresses of the inputted packets. In various AP links, the
packets from different IP addresses are allocated to different
member links, and those from the same IP addresses use the
same member links.
src-dst-mac: The traffic is distributed according to the soruce
and destination MAC addresses. Packets with different source-
destination MAC addresses are forwarded to different member
links. The packets with the same source-destination MAC
addresses are forwarded from the same member link.
To restore the AP traffic balancing configuration to default, run the following command in the
global configuration mode:no aggregateport loag-balance command

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English