D-Link xStack DGS-3610 Series User Manual

Chapter 37 Configuration of 802.1X DGS-3610 Series Configuration Guide
37-4
For complete descriptions of the commands mentioned in this chapter, see the related
chapters in the Security Configuration Command Reference.
37.5.2 Enabling AAA
It is required to enable AAA first to use the AAA security features.
To enable AAA, execute the following command in the global configuration mode:
Command
Function
DGS-3610(config)# aaa new-model
Enable AAA
37.5.3 Disabling AAA
To disable AAA, execute the following command in the global configuration mode:
Command
Function
DGS-3610(config)# no aaa new-model
Disable AAA
37.5.4 Subsequent Configuration Steps
After the AAA is enabled, you can configure the other parts related with the selected security
solutions. The following table lists the possible configuration tasks and their description
chapters.
Methods of AAA access control security solution
Configuration task
Step
Chapter
Configuring Local Login Authentication
3
Configuring authentication
Defining AAA Authentication Method List
3
Configuring authentication
Applying Method List on Specific Interface or
Line
4
Configuring authentication
Configuring Radius Security Protocol
Parameters
2
Configuring Radius
Enabling Radius Authorization
5
Configuring authorization
If you are using AAA for authentication, see Configuring Authentication.
37.6 Configuring Authentication
ID authentication means a user is authenticated before the use of network resources. In
most cases, the authentication is implemented with the AAA security features. We
recommend the use of AAA.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English