D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 7 Aggregate Port Configuration
7-3
Figure 7-2 AP traffic balancing
Source MAC based traffic
distribution
Destination MAC based
traffic distribution
Aggregate Link
7.2 Configuring Aggregate Port
7.2.1 Default Configurations of Aggregate
Port
The default configurations of AP are shown in the table below.
Attribute
Default value
Layer-2 AP interface
None
Layer-3 AP interface
None
Traffic balancing
Trafficbalancing is distributed according to the source MAC addresses
of the input packets.
The defaut traffic balancing of DGS-3610 series switches is balanced
according to the source MAC address+destination MAC address
input.
7.2.2 Configuration Guide for Aggregate
Port
The speed rates of the AP member ports must be coherent.
L2 ports can only be added to a L2 AP, and L3 ports can only be added to a L3 AP.
The AP cannot be set with any port security function.
When a port is added to an AP that does not exist, the AP will be created automatically.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English