D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 17 MSTP Configuration
17-33
Command
Function
DGS-3610# copy running-config
startup-config
Save the configuration.
To disable the BPDU source MAC check, run no bpdu src-mac-check in the interface
mode.
17.4.8 Disabling the Automatic Identification
of Edge Ports
If a specified port has not received the BPDU in a certain time (3 seconds), the port is
automatically recognized as an edge port. However, the Port Fast Operational State may be
disabled due to the receiving if BPDU. This function is enabled by default.
In the privileged mode, you can set Autoedge by performing the following steps:
Command
Function
DGS-3610# configure terminal
Enter the global configuration mode.
DGS-3610(config)# interface
Interface-id
Enter the configuration mode of this interface, and the
legal interface includes the physical port and the
Aggregate Link.
DGS-3610(config-if)# spanning-tree
autoedge
Enable the autoedge of this interface.
DGS-3610(config-if)# end
Return to the privilege mode.
DGS-3610# show spanning-tree
interface interface-id
Check the configuration entities.
DGS-3610# copy running-config
startup-config
Save the configuration.
If you want to disable the Autoedge, use the spanning-tree autoedge disabled command
to set in the interface configuration mode.
17.5 Showing MSTP Configuration
and Status
MSTP provides the following show commands for viewing configuration information and
runtime information. Functions of each command are depicted below:
Command
Meaning
DGS-3610# show spanning-tree
Show parameter information of MSTP and topology
information of the spanning tree

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English