Currently, our product does not support the following functions, but will
support them in future versions;
OSPF line on-demand support, as defined in RFC 1793;
Function of OSPF Graceful Restart, as defined in RFC 3623 and RFC
4167;
Module of PE-CE OSPF routing in the network of BGP/MPLS VPN, as
defined in RFC 4576 and RFC4577;
OSPF fast summary;
28.2 OSPF Configuration Task List
The configuration of OSPF should be cooperated with various devices (including internal
devices, area boundary routers and autonomous system boundary routers). When no
configuration is performed, the defaults are used for various parameters of the routers. In
this case, Both sending and receiving packets do not need authentication, and the
interface does not belong to any devision of the autonomous system. When you change the
default parameters, you must ensure that the devices have the same configuration settings.
To configure the OSPF, you must perform the following tasks. Among them, activating the
OSPF is required, while others are optional, but may be required for particular applications.
The steps to configure the OSPF routing protocols are described as below:
Creating the OSPF routing process (required)
Configuring the OSPF interface parameters (optional)
Configuring the OSPF to accommodate different physical networks (optional)
Configuring the OSPF area parameters (optional)
Configuring the OSPF NSSA area (optional)
Configuring the route summary between OSPF areas (optional)
Configuring route summary when routes are injected to the OSPF (optional)
Creating the virtual connections (optional)
Creating the default routes (optional)
Using the Loopback address as the route ID (optional)
Changing the OSPF default management distance (optional)
Configuring the route calculation timer (optional)
LSA pacing (optional)
Route selection configuration (optional)
Configuring whether to check the MTU value when the interface receives the database
description packets (optional)
Configuring to prohibit an interface from sending the OSPF interface parameters
(optional)
To Next Page
Loading...
Need help?
General