D-Link xStack DGS-3610 Series User Manual

Chapter 25 SNMP Configuration DGS-3610 Series Configuration Guide
25-10
Command
Function
DGS-3610(config-if)# no snmp-server
enable traps
Enable or disable the function to send the link
trap for the interface.
No link trap will be sent for the interface according to the following configuration.
DGS-3610(config)# interface gigabitEthernet 1/1
DGS-3610(config-if)# no snmp trap link-status
25.2.11 Configuring Message Sending
Operation Parameters
It is possible to specify the parameters for Agent to send Trap messages by executing the
following commands:
Command
Function
DGS-3610(config)# snmp-server trap-source
interface
Specify the source interface for sending Trap
messages.
DGS-3610(config)# snmp-server
queue-length length
Specify the length of each Trap message queue.
DGS-3610(config)# snmp-server
trap-timeout seconds
Specify the interval for sending Trap messages.
25.3 SNMP Monitoring and
Maintenance
25.3.1 Checking Current SNMP Status
To monitor the SNMP status and troubleshoot SNMP configurations, our product provides
the monitoring commands for SNMP, with which it is possible to easily view the SNMP status
of the current network device. In the privileged user mode, execute show snmp to view the
current SNMP status.
DGS-3610# show snmp
Chassis: 1234567890 0987654321
Contact: wugb@i-net.com.cn
Location: fuzhou
2381 SNMP packets input
5 Bad SNMP version errors
6 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
9325 Number of requested variables
0 Number of altered variables
31 Get-request PDUs
2339 Get-next PDUs

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English