D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 37 Configuration of 802.1X
37-9
 Configuring On-line Client Probe
 Configuring the Option Flag for EAPOL Frames to Carry TAG
37.2.1 Default Configuration of 802.1X
The following table lists some defaults of the 802.1X
Item
Default
Authentication
DISABLE
Accounting
DISABLE
Radius Server
*ServerIp
*Authentication UDP port
*Key
*No default
*1812
*No default
Accounting Server
*ServerIp
*Accounting UDP port
*No default
*1813
All port types
Uncontrolled port (all ports can perform
communication directly without authentication)
Timed re-authentication
Off
Timed reauth_period
3,600 seconds
Interval between two authentication requests
10 seconds
Retransmission interval
3 seconds
Maximum retransmissions
3
Client timeout period
3 seconds, if within which no response is received
from the client, the communication is deemed as a
failure
Server timeout period
5 seconds, if within which no response is received
from the server, the communication is deemed as a
failure
Lists of authenticable hosts under a port
No default
37.2.2 Precautions for Configuring 802.1X
 You can perform the following configuration only to the products that support 802.1X.
 The 802.1X can run on both L2 device and L3 device.
 It is required to configure the IP address of the authentication server before the
Radius-server authentication mode can operate normally.
 You cannot enable 1X authentication for ports with safety feature enabled.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English