D-Link xStack DGS-3610 Series User Manual

Chapter 37 Configuration of 802.1X DGS-3610 Series Configuration Guide
37-34
Command
Function
configure terminal
Enter the global configuration mode.
dot1x auth-address-table address
mac-addr interface interface
Set the list of the hosts that can be authenticated.
end
Return to the privileged mode.
write
Save the configuration.
show dot1x auth-address-table
Show the list of the hosts that can be authenticated.
Use the no dot1x auth-address-table address command to delete the specified
authenticable host list. The following example shows the list of the hosts that can be
authenticated.
DGS-3610# show dot1x auth-address-table
interface:g3/1
-----------------------------------
mac addr: 00D0.F800.0001
37.3.4 Viewing the User Authentication
Status Information
The administrator can view the authentication status of the current users of the switch for
easier troubleshooting.
In the privileged mode, you can view the user authentication status information through the
following steps:
Command
Function
show dot1x summary
Viewing the user authentication status information
The following example shows the user authentication status information.
DGS-3610# show dot1x summary
ID MAC Interface VLAN Auth-State Backend-State Port-Status
---- ----------- --------- ---- ---------- ------------ -----------
1 00d0f8000001 Gi3/1 1 Authenticated IDLE Authed
37.3.5 Showing the 1x Client Probe Timer
Configuration
In the privileged mode, you can view the 1x timer setting through the following steps:
Command
Function
show dot1x probe-timer
Show the 1X timer setting
The following example shows the 1.1x timer setting:
DGS-3610# show dot1x probe-timer

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English