EasyManuals Logo

D-Link xStack DGS-3610 Series User Manual

D-Link xStack DGS-3610 Series
703 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
Chapter 2 Configuration of Switch Basic Management DGS-3610 Series Configuration Guide
2-2
password is encrypted before stored into the configuration file, and the clear text password is
changed to the encrypted text password. The enable secret command uses a private
encryption algorithm.
2.2.2 Default Password and Privilege Level
Configuration
By default, there are not passwords of any levels, and the default level is 15.
2.2.3 Configuring or Changing Passwords
of Different Levels
Our prodects provide the following commands for setting or changing the passwords at
different levels.
Command
Purpose
DGS-3610(config)# enable password
[level level] {password | encryption-type
encrypted-password}
Set static password. Currently only 15-level user
passwords are allowed, which may become active only
when a security password has not been set.
If a non-15-level password is set, the system will give a
prompt and automatically turn it into the security
password.
If the 15-level static password set is the same as the
15-level security password, the system will give a
warning message.
DGS-3610(config)# enable secret [level
level] {encryption-type
encrypted-password}
Set the security password, which has the same
function as the static password but a better password
encryption algorithm has been adopted. For the
purpose of security, the security password is always
recommended.
DGS-3610# enable [level] and
DGS-3610# disable [level]
Switch the user level. The password for the
corresponding level is required when a lower level is
switched to a higher level.
When setting a password, the keyword level is used to define the password for a specified
privilege level. When a password is set for a specified level, the password provided is only
applicable for the users who are accessing that level.
2.2.4 Configuring Multiple Privilege Levels
By default, the software has only two password protection modes: normal user (level 1) and
privileged user (level 15). You can configure up to 16 authorized levels of commands for

Table of Contents

Other manuals for D-Link xStack DGS-3610 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DGS-3610 Series and is the answer not in the manual?

D-Link xStack DGS-3610 Series Specifications

General IconGeneral
BrandD-Link
ModelxStack DGS-3610 Series
CategorySwitch
LanguageEnglish

Related product manuals