To Next Page

To Previous Page

Chapter 24 UDP-Helper Configuration DGS-3610 Series Configuration Guide

24-2

24.2.2 Enable the Function of Relay and

Forwarding for UDP-Helper

Command

Function

DGS-3610(config)# udp-helper

enable

The Command udp-helper enable is used to enable

the function of relay and forward for UDP broadcast

packet. This function is disabled by default.

The command no udp-helper enable is used to disable the function of relay and forwarding

for the UDP.

Note

1. The function of relay and forwarding is disabled by default.

2. When enabling the function of relay and forward for UDP broadcast

packets, the broadcast packets of UDP Ports 69, 53, 37, 137, 138 and

49 are relayed and forwarded by default.

3. When the function of relay and forward for UDP broadcast is disabled,

all of the configured UDP ports including the default ports are

cancelled.

24.2.3 Configuring Destination Server for

Relay and Forward

Command

Function

DGS-3610(config-if)# ip helper-address

IP-address

Configure the destination server to which the UDP

broadcast packets are relayed and forwarded. By

default, it is not configured.

The command no ip helper-address can be used to remove the destination server of relay

and forwarding.

Note

1. At most 20 destination servers can be configured for one interface.

2. If the destination server for relay and forwarding is configured on a

specified interface, when the UDP-Helper is enabled, the broadcast

messages of specified UDP port received from this interface will be

sent to the destination server configured for this interface by means of

unicast.

D-Link xStack DGS-3610 Series User Manual

Other manuals for D-Link xStack DGS-3610 Series