D-Link xStack DGS-3610 Series

Chapter 34 OSPFv3 Configuration DGS-3610 Series Configuration Guide
34-4
34.1.4 Authentication Mechanism Setting
The OSPFv2 itself supports two authentication modes: plain text authentication and key
authentication based on MD5. The OSPFv3 itself does not provide any authentication. It will
use the IPSec authentication mechanism. In the future, we will support the IPSec
authentication mechanism.
34.2 OSPFv3 Basic Configuration
The OSPFv3 protocol of DGS-3610 series has the following features:
 Supports multi-instance OSPF;
 Supports network type setting;
 Supports virtual link;
 Supports passive interfaces;
 Supports an interface to select a participant OSPF entity;
 Supports sub intervals (Stub area);
 Supports route redistribution;
 Supports route information aggregation;
 Supports timer setting;
Subsequent support:
 Supports NSSA areas;
 Supports authentication. The OSPFv3 will use the IPSec authentication mechanism.
Default OSPFv3 configuration:
Router ID
Undefined
Interface
Configuration
Interface type
Broadcast network
Interface cost
Undefined
hello packet sending interval
10 seconds
Dead interval:
4 times of the hello packet interval.
LSA sending delay
1 second
LSA retransmit interval.
5 seconds
Priority
1
MTU check of database
description packets
Enabled