D-Link xStack DGS-3610 Series User Manual

Chapter 35 IP Multicast Routing Configuration DGS-3610 Series Configuration Guide
35-20
Command
Function
DGS-3610(config)# ip igmp ssm-map static
11 192.168.2.2
All groups that comply with acl 11 will be mapped
into the source address 192.168.2.2.
35.6.14 ClearingUp Dynamic Group
Membership in IGMP Cache from
Response Message
To clear up dynamic group member information acquired from response message which is
stored in IGMP cache, execute the following command in the privilege mode:
Command
Function
DGS-3610# clear ip igmp group
Clear up the dynamic group membership in the
IGMP cache from responding message.
No parameter indicates clearing up all information
of the igmp group.
35.6.15 Clearing Up All Information on
Specified Interface in IGMP Cache
To clear up all information of specified interface in the IGMP cache, execute the following
command in the privilege mode:
Command
Function
DGS-3610# clear ip igmp interface
interface-type
Clear up the message on the interface in the IGMP
cache.
35.6.16 Displaying the Status of IGMP Group
Member in Directly-connected Subnet
Execute the following command in privileged mode to display the status of IGMP group
member in directly-connected subnet:
Command
Function
DGS-3610# show ip igmp groups
Show the status of IGMP group member in
directly-connected subnet.
DGS-3610# show ip igmp groups detail
Show the details of all members in the
directly-connected subnets.
DGS-3610# show ip igmp groups
A.B.C.D
Display the status of specified group member in
directly-connected subnet.

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English