D-Link xStack DGS-3610 Series

Chapter 38 Radius Configuration DGS-3610 Series Configuration Guide
38-2
Figure 38-1 Typical RADIUS network configuration
WAN
PC 1
PC 2
NAS
RADIUS Server
38.2 RADIUS Configuration Tasks
To configure Radius on the network device, perform the following tasks first:
 Enable AAA. For the details, see AAA Overview.
 Define the RADIUS authentication method list through the aaa authentication
command. For details about how to use aaa authentication to define the authentication
method list, see Configuring Authentication.
 Apply the defined authentication list on the specific line; otherwise the default
authentication list will be used for authentication. For more details, see Configuring
Authentication.
After the configuration is completed, you may start to configure the RADIUS. The
configuration of the RADIUS consists of the following parts:
 Configuring Radius Protocol Parameters
 Specify the RADIUS authentication.
38.2.1 Configuring Radius Protocol
Parameters
Before configuring the Radius on the network device, the network communication shall
operate perfectly on the Radius server. To configure RADIUS protocol parameters, run the
following commands:
Command
Function
configure terminal
Enter the global configuration mode.