D-Link xStack DGS-3610 Series User Manual

DGS-3610 Series Configuration Guide Chapter 39 SSH Terminal Service
39-3
Command
Description
configure terminal
Enter the configuration mode
no enable service ssh-server
Disable the SSH Server.
39.4.5 Configuring SSH Server Support
Version
By default, the SSH Server V1 and V2 are compatible. You can configure the SSH version
through the following commands.
Command
Description
configure terminal
Enter the configuration mode.
ip ssh version {1 | 2}
Configure the SSH support
version.
no ip ssh version
Reset SSH to the default
configuration, supporting
SSHv1 and SSHv2.
39.4.6 Configuring SSH User Authentication
Timeout Duration
By default, the user authentication timeout duration of the SSH SERVER is 120 seconds.
Run the following commands to configure the SSH user authentication timeout duration.
Command
Description
configure terminal
Enter the configuration mode
ip ssh time-out time
Configure the SSH timeout duration (1-120sec)
no ip ssh time-out
Reset the SSH user authentication timeout duration to
the default value, 120 seconds.
39.4.7 Configuring SSH Re-authentication
Times
This command is used to set the authentication attempts for SSH user requesting
connections to prevent illegal actions such as malicious guesswork. The authentication
attempts are set to 3 times for the SSH Server by default. A user can enter the username
and password for three times to attempt the authentication. Run the following commands to
configure the SSH re-authentication times:
Command
Description
configure terminal
Enter the configuration mode

D-Link xStack DGS-3610 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3610 Series
Category	Switch
Language	English