D-Link xStack DGS-3610 Series

Chapter 41 Anti-attack System Guard Configuration DGS-3610 Series Configuration Guide
41-6
Command
Meaning
clear system-guard
[interface interface-id
[ip-address ip-address]]
Clear Isolated Users.
Where, clear system-guard indicates clearing all
isolated users;
clear system-guard interface interface-id indicates
clearing all users under that port;
clear system-guard interface interface-id ip-address
ip-address indicates clearing the specified IP user under
the interface.
41.2.8 Viewing Related Information of
System Guard
41.2.8.1 View Related Information of System Guard
Execute the show system-guard command to view the configuration parameters of the
system guard:
Command
Meaning
show system-guard [interface
interface-id]
View the configuration parameters of the system guard.
Here is an example:
DGS-3610# show system-guard
detect-maxnum number : 100 ------ The maximum quantity of the hosts monitored by the
device
isolated host number : 11 ----- The quantity of the hosts isolated by the device
inteface state isolate time same-attack-pkts scan-attack-pkts
---------------------------- ---------------- ------------------
Fa 0/1 ENABLE 120 20 10
Fa 0/2 DISABLE 110 21 11
……
DGS-3610# show system-guard interface Fa 0/1
detect-maxnum number : 100 ------ The maximum quantity of the hosts monitored by the
device
isolated host number : 11 ------------ The quantity of the hosts isolated by the device
intefacestate solate time ame-attack-pkts scan-attack-pkts
---------------------------- ----------------
Fa 0/1 ENABLE 120 20 10