D-Link xStack DGS-3610 Series

DGS-3610 Series Configuration Guide Chapter 6 Configuring Interfaces
6-19
OutUcastPkts : 17284
OutMulticastPkts : 249
OutBroadcastPkts : 336
Undersize packets : 0
Oversize packets : 0
collisions : 0
Fragments : 0
Jabbers : 0
CRC alignment errors : 0
AlignmentErrors : 0
FCSErrors : 0
dropped packet events (due to lack of resources): 0
packets received of length (in octets):
64:46264, 65-127: 47427, 128-255: 3478,
256-511: 658, 512-1023: 18016, 1024-1518: 125
6.4 LinkTrap Policy Configuration
In the devices, you can configure whether the LinkTrap of this interface will be sent on the
basis of the interface configuration. When the function is enabled, if the Link status is
changed for the interface, SNMP will send the LinkTrap. Otherwise, it will not be sent. By
default, this function is enabled.
6.4.1 Configuring Command
Command
Function
DGS-3610(config-if)# [no] snmp trap
link-status
Enable or disable the function for sending the
link trap of this interface.
6.4.2 Configuration Example
The following configuration shows how to configure the interface to unforwarding Link trap:
DGS-3610(config)# interface gigabitEthernet 1/1
DGS-3610(config-if)# no snmp trap link-status