DGS-3610 Series Configuration Guide Chapter 32 IPv6 Configuration
preferred-lifetime] | [at
valid-date preferred-date]
| infinite | no-advertise]]
ipv6 nd ra-lifetime
seconds
(Optional) Set the TTL of the router in the router
advertisement (RA) message, namely the time as
the default router. When the setting is 0, it indicates
that it will not act as the default router of the
direct-connected network.
ipv6 nd ra-interval
seconds
(Optional) Set the time interval for the router to send
the router advertisement (RA) message periodically.
ipv6 nd
managed-config-flag
(Optional) Set the ―managed address configuration‖
flag bit of the router advertisement (RA) message,
and determine whether the host will use the stateful
auto-configuration to obtain the address when it
receives this router advertisement (RA).
ipv6 nd other-config-flag
(Optional) Set the ―other stateful configuration‖ flag
bit of the router advertisement (RA) message, and
determine whether the host will use the stateful
auto-configuration to obtain other information other
than the address when it receives this router
advertisement (RA).
(Optional) Set whether suppress the router
advertisement (RA) message in this interface.
Return to the privileged EXEC mode.
show ipv6 interface
[interface-id] [ra-info]
Show the ipv6 interface of the interface or the
information of RA sent by this interface.
copy running-config
startup-config
(Optional) Save the configuration.
The no command of above commands can be used to restore the default value.
32.3 IPv6 Monitoring and Maintenance
It is mainly used to provide related command to show some internal information of the IPv6
protocol, such as display the ipv6 information, the neighbor table and the route table
information of the interface.
show ipv6 interface [interface-id] [ra-info]
Show the IPv6 information in the interface.
To Next Page
Loading...
Need help?
General