EasyManuals Logo

D-Link xStack DGS-3610 Series User Manual

D-Link xStack DGS-3610 Series
703 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #665 background imageLoading...
Page #665 background image
DGS-3610 Series Configuration Guide Chapter 47 RLDP Configuration
47-5
47.2.2 Configuring Global RLDP
The port RLDP works only when the global RLDP is enabled.
In the global configuration mode, follow these steps to enable RLDP:
Command
Function
DGS-3610(config)# rldp enable
Turn on the global RLDP function switch.
DGS-3610(config)# end
Return to the privileged mode.
The no option of the command turns off the global RLDP.
47.2.3 Configuring Port RLDP
The RLDP operation is port-based, so the user needs to explicitly configure specific ports
that need RLDP running. In configuring the port RLDP, you need to specify the diagnosis
type and the troubleshooting method for the port at the same time. The diagnosis types
include unidirection-detect, bidirection-detect and loop-detect. The troubleshooting methods
include warning, block, shutdown-port, and shutdown-svi.
In the configuration mode, follow these steps to configure port RLDP:
Command
Function
DGS-3610(config)# interface interface-id
Enter the interface mode.
DGS-3610(config-if)# rldp port
{unidirection-detect | bidirection-detect
| loop-detect }
{warning | shutdown-svi | shutdown-port
| block}
Enable the RLDP on the port and configure the
diagnosis type and troubleshooting method at the
same time.
DGS-3610(config-if)# end
Return to the privileged mode.
The no option of the command disables the RLDP on the port and the configured detection
types one by one.
In the example below, the RLDP is configured on GigabitEthernet 0/5, and multiple diagnosis
types and troubleshooting methods are specified:
DGS-3610# configure terminal
DGS-3610(config)# interface gigabitEthernet 0/5
DGS-3610(config-if)# rldp port unidirection-detect
shutdown-svi
DGS-3610(config-if)# rldp port bidirection-detect warning
DGS-3610(config-if)# rldp port loop-detect block
DGS-3610(config-if)# end
DGS-3610# show rldp interface gigabitEthernet 0/5
port state : normal
local bridge : 00d0.f822.33ac
neighbor bridge : 0000.0000.0000
neighbor port :

Table of Contents

Other manuals for D-Link xStack DGS-3610 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link xStack DGS-3610 Series and is the answer not in the manual?

D-Link xStack DGS-3610 Series Specifications

General IconGeneral
BrandD-Link
ModelxStack DGS-3610 Series
CategorySwitch
LanguageEnglish

Related product manuals